PCV – Linear Shift Sensor (Push Type)

kr 4.533,00 Inkl.MVA

Linear Travel Sensor Kit – Noen sykler har ikke noe girstag, eller det er ikke plass til Shift Rod Sensor, da er en «Linear Travel Sensor» løsningen. Den ene enden festes til girvelgeren og den andre enden til et fast punkt på motoren eller chassis. sensoren(følerne) finnes både som «skyv» og «dra»-variant, avhengig av hva som passer din sykkel. Ett universielt monteringskit er inkludert.

Produktnr: 4-116 Kategorier: , , Stikkord:

Beskrivelse

SHIFT SENSOR PC-V PUSH LN
Races are won or lost in fractions of a second
Dynojet’s Quick Shifter (DQS) kit allows full-throttle, clutchless upshifts in racing and performance riding applications
The shift rod pressure/tension sensor kit is a universal sensor that mounts to the shift rod in either a push or pull configuration
Requires modification of gear-linkage tie-rod
The linear travel sensor kit works with bikes that have no shift rod, or on those the shift rod sensor will not fit
Mount one end to the shift lever and the other to a fixed point on the chassis
Push or pull-types available with universal mounting kit
Plugs directly into the Power Commander expansion port with no re-wiring required
Power Commander Control Center software lets you set engine dead time during upshifts and minimum rpm for system operation

NOTE: To order either of the above sensors, you must find the correct direction of movement during an upshift (push or pull). For the shift rod/pressure/tension sensor, press on the shift lever in the direction of an upshift to see if the rod is pushing or pulling on the clevis on the shift shaft. For the linear travel sensor, also move the shifter for an upshift. If movement is down, a pull sensor is needed. If movement is up, a push sensor is required.

Omtaler

Det er ingen omtaler ennå.

Bare innloggede kunder som har kjøpt dette produktet kan legge igjen en omtale.

Du liker kanskje også…